Viper 4105V - Valet Take-Over

Valet
Toke-Over
The
Valet
Take-Over feature
allows
the
vehicle to remain running after
the
key
has
been removed from
the
ignition.
This
feature
is
useful
for
occasions when you wish
to
exit and
lock
the
vehicle
for short periods
of
time, but
would like
to
leave
the
engine running and
the
climate
controls on.
To
perform
Valet Take-Over:
1 .
Before turning off
the
engine,
press
and
release * on
the
remote
control
for
1
second.
2.
Turn
the
ignition key
to
the
OFF
position.
The
engine will stay
run-
ning until
the
pre-programmed time
has
elapsed
or a shutdown
input
is
received.
(See
the
previous
Remote
Start
section for a
complete
list
of
shut-down inputs.)
Important:
This
feature
will
not work if
the
brake
pedal
1s
being
pressed.
Cor
Finder
Car
finder allows you
to
locate
your vehicle,
by
having
the
system
flash
the
parking lights.
To
activate:
1 .
Press
and release
the
*
and
~Mb.\
buttons at
the
same time.
2.
The
lights flash
5 times slowly allowing you
to
locate
your
ve-
hicle.