Government
Regulations
This
device complies with
Part
15
of FCC
rules.
Operation
is
subject
to
the
fol-
lowing two conditions: (
1)
This
device may not cause harmful interference, and
(2)
This
device
must
accept any interference received,
including
interference that
may cause undesirable operation.
This
equipment has been tested and found to comply with
the
limits for a
class
B
digital device, pursuant to
Part
15
of
the
FCC
Rules.
These
limits are designed to
provide reasonable protection against harmful interference
in
a residential instal-
lation.
This
equipment generates and can radiate radio frequency energy and,
if not
installed
and
used
in
accordance with
the
instruction manual, may cause
harmful interference to radio communications. However, there
is
no guarantee
that interference
will
not occur
in
a particular installation.
If
this
equipment does
cause harmful interference to radio or television, which can be determined by
turning
the
equipment
OFF
and
ON,
the
user
is
encouraged to try
to
correct
the
interference by one or more
of
the
following measures:
•
Reorient or relocate
the
receiving antenna.
• Increase
the
separation between
the
equipment and receiver.
• Connect
the
equipment into an outlet
on
a circuit different from that to which
the
receiver
is
connected.
•
Consult
the
dealer or an experienced radio /
TV
technician for help.
This
device complies with
the
Industry
Canada
Radio Standards Specification
RSS
210.
Its
use
is
authorized only on a no-interference, no-protection basis;
in
other words,
this
device
must
not be
used
if
it
is
determined that it causes harm-
ful
interference to services authorized by
IC.
In
addition,
the
user
of
this
device
must
accept any radio interference that may be received, even if
this
interference
could affect
the
operation
of
the
device.
Warning:
Changes or modifications not expressly approved by
the
party responsible for .
compliance could void
the
user's
authority
to
operate
this
device.
©
2012
Directed.
All
rights reserved.
1 1
To Next Page
Loading...
