Viper 4811V - Page 47

22
© 2015 Directed. All rights reserved.
Bitwriter - Only Options
If programming with the Bitwriter or XKLoader 3, the Learn Routine can be locked or unlocked. If the
Learn Routine has previously been locked, it must be unlocked with Bitwriter - this cannot be done
manually with the Control Center button.
The Bitwriter
or XKLoader 3 gives you access to a wider range of system options. These features and the
adjustments that may be programmed are described in the table below.
Item Feature
Default
Opt. 2 Opt. 3 Opt.4 Opt. 5+
1 Aux/Trunk Icon Type*
Trunk
Window Sunroof Audio Lights/Left dr/Right dr/Rear
Hatch
2 AUX 1 Timed Output (seconds)
30 sec.
Options: 1 to 90 sec.
3 AUX 1 Remote Icon Type*
Pulsed
Trunk Window Sunroof Audio/Lights/Left dr/Right dr/
Rear Hatch/Timed/Latched
4 AUX 2 Timed Output (seconds)
30 sec.
Options: 1 to 90 sec.
5 AUX 2 Icon Type*
Pulsed
Trunk Window Sunroof Audio/Lights/Left dr/Right dr/
Rear Hatch/Timed/Latched
6 AUX 3 Timed Output
30 sec.
Options: 1 to 90 sec.
7 AUX 3 Icon Type*
Pulsed
Trunk Window Sunroof Audio/Lights/Left dr/Right dr/
Rear Hatch/Timed/Latched
8 AUX 4 Timed Output (seconds)
30 sec.
Options: 1 to 90 sec.
9 Remote Start Runtime (minutes)
12 min.
Options: 1 to 60 min.
10 Timer Mode Runtime
(minutes)
12 min.
Options: 1 to 16 min.
11 Timer Mode Starts
6 starts
Options: 1/2/3/4 to 24 (Starts) in increments of 2
12 Timer mode intervals (hours)
3 hr.
Options: 1/2/3/4 to 24 in 2 hour increments
13 Smart start low temp
(Fahrenheit)
0° (F)
Options: OFF, -20° to 70° in 10° increments
14 Smart start high temp
(Fahrenheit)
100° (F)
Options: OFF, 40° to 130° in 10° increments
15 Smart start low battery (volts)
10.5V
Options: OFF, 9V to 12.5V in 0.5V increments
16 Diesel Start Delay type (seconds)
15 sec.
Options: 1 to 90 sec.
17 Starter Release Fine Tune
6 (normal)
Options: 0 to 20 in increments of 1
18 Virtual Tach Fine Tune
(milliseconds)
Not
Initialized
Options: Not initialized, 0 to 1000 in 50 millisecond increments
19 Transmitter Programming
Unlocked
Locked
20 Feature Programming
Unlocked
Locked
* Feature only available for the LCD 2-way remote control with display screens.
Note: The Bitwriter is a hand held Feature Programming tool that can be used to fine tune and access certain
features that are not accessible with manual programming. The Bitwriter plugs into the black 3-pin plug on the
system. The black 3-pin port will also be utilized by the optional Smartstart module when applicable.