35
© 2008 Directed Electronics. All rights reserved.
7. Transmit. While holding the Valet/Program switch,
press the
button on the remote control. The unit chirps to
confirm that the code has been successfully programmed. It
is not possible to teach a remote control button to the
system more than once.
8. Release. Once the code is learned, the Valet/Program
switch can be released. You can advance from one function
step to another by releasing the Valet/Program switch and
tapping it to advance function steps and then holding it.
Learn Routine is exited if:
The door is closed•
The ignition is turned off•
The program switch is pressed too many times•
More than 30 seconds elapses between steps•
To Next Page
Loading...
