50
© 2008 Directed Electronics. All rights reserved.
input on the remote start unit. When the vehicle is running press the button the
appropriate amount of times to activate the remote start (factory setting is for 1
pulse). The remote emits a confirmation tone. You can then turn Off the ignition
and the car remains running for the pre-programmed amount of time.
Note:
For this feature to work the “turbo timer run time” mode needs to be
programmed ON and the tachometer wire on the remote start needs to be con-
nected and programmed.
3-7 Timer Mode Run Time—12min (1)
, 3(2), 6 (3), 9 (4) MINUTES: Selects
the time in minutes that the system operates the engine until the system “times
out” when the remote start activates in timer mode. The system may be shut
down using a shutdown at any time. Using the Bitwriter®, the run time can be
programmed for any duration from 1-16 minutes.
Note:
The numbers in parentheses indicate the number of times the LED flashes.
3-8 Flex Relay Function:
Ignition 2 (1) In the factory setting, the flex relay func-
tions the same as the pink ignition 1 wire, in accessory (2) setting the flex relay
functions the same as the Orange accessory 1 wire, in starter (3) setting the flex
relay functions the same as the purple starter 1 wire.
3-9 Diesel Timer—Wait-To-Start Input
(1)
- 15 (2), 30 (3), or 45 (4) seconds.
Default is the “Wait-to-Start” input control wire, or programmable to ignore
the input control wire by a delay of 15 ,30, or 45 seconds. This feature can
also be optionally programmed with the Bitwriter®, with a delay from 1 to 90
seconds in one second increments.
Note:
The numbers in parentheses indicate the number of times the LED flashes.
3-10 Accessory State During Wait-To-Start:
On (1)
OFF (2): This feature allows
the selection of the accessory output to be ON or OFF during wait-to-start. Use
the two-chirp setting for OFF.
3-11 2nd Status Output:
Normal (1) Latched (2) Pulsed (3): This feature allows
selection of status output or a rear defogger mode that turns on ten seconds after
the vehicle has started if the vehicle interior temperature is below 55 degrees F.
The defogger mode has two selections, latched, or pulsed. Latched mode only
To Next Page
Loading...
