51
© 2008 Directed Electronics. All rights reserved.
stays on for 10 minutes.
Note:
When the defogger mode is on, the output is always active and can
be turned on independently with the remote for a one-time activation. (See the
Remote Functions table.)
3-12 Parking Lights:
Constant (1) Flashing (2) OFF (3)
:
In the default setting, the
parking lights (if connected) comes on solid during the remote start runtime. In
the two- flash setting the parking lights flashes during the remote start runtime. In
the OFF setting, the parking lights do not come ON or flash, when the vehicle
is remote started.
3-13 Anti-Grind:
On (1) OFF (2)
:
With the anti-grind On (default) the ground-
when-armed output is active during remote start operation. This activates the
starter kill relay and prevents the customer from re-cranking the car with the key,
when doing key takeover. If accessories such as a voice module or window
module are added to the unit, it may be necessary to use the two-chirp setting
to program this feature OFF.
3-14 Tach Mode Starter Release:
Normal (1) Increase (2) Decrease (3): Use the
two-chirp setting to increase time by 15% of the original tach programmed time.
Use the three chirp setting to decrease by 15% of the original programmed
time.
3-15 Vehicle temperature auto report:
ON (1) or OFF (2). The default setting is
OFF. When programmed ON the main unit stores the interior temperature of the
vehicle in its temporary memory. When the vehicle’s interior temperature chang-
es 1 degree Celsius, the main unit automatically sends the interior temperature
message to the remote and the LED’s light up accordingly to display the current
temperature (See Owner’s Guide for temperature description).
Note:
Only available when upgrading to a two way remote
To Next Page
Loading...
