12
© 2011 Directed Electronics. All rights reserved.
Advanced Commands: (Level 1)
Press and release the button 1 time. The LED illuminates indicat-
ing Level 1
Silent Arm
Press and release
The alarm arms, doors lock (if connected), and the parking lights flash
once. The Arm LED turns on to confirm. Valet mode* or Trigger Zone
Fault Report** messages may be received.
Silent Disarm
Press and release
The alarm disarms, doors unlock (if connected), and the parking lights
flash twice. The Disarm LED turns on to confirm. The Silent Disarm
output may be replaced by the Alarm Report**
Runtime Reset
Press and release
If more time is needed while remote start is active, runtime reset will
reset the runtime counter to the pre-programmed setting. The green
ghost LED’s show the runtime and the Remote start On tones play to
confirm runtime reset.
Note
Remote Start must be On to use this feature.
To Next Page
Loading...
