What to do if my Viper Fang 24T has no power?
If your Viper Scrubber has no power, there are several potential causes. The batteries might be bad and need replacement. Alternatively, the batteries may need charging. Check if any battery cables are loose and tighten them. Finally, ensure the batteries are connected properly, following the installation instructions.
Why does my Viper Fang 24T Scrubber have a short run time?
A short run time in your Viper Scrubber can be due to several reasons. The batteries may need to be charged. It could also indicate that the batteries require maintenance. Another possibility is a bad cell in one or more of the batteries, requiring replacement. Finally, the charger itself might be faulty and need replacement.
What to do if my Viper Fang 24T Scrubber has little or no solution flow?
If your Viper Scrubber experiences little or no solution flow, the solution filter might be clogged; remove and clean it. Another cause may be an obstructed solution line; remove the solution line and clean it. Also, the solution flow adjustment knob may need adjustment. Increase flow by twisting the solution adjustment knob to the right, or decrease flow by twisting it to the left.
What to do if the brush motor does not run on my Viper Scrubber?
If the brush motor on your Viper Scrubber isn't running, the brush circuit breaker might have tripped. Check the brush motor for any obstructions and reset the breaker. Unfortunately, if this doesn't solve the issue, further troubleshooting requires contacting a Viper Distributor.
General| Category | Scrubber |
|---|---|
| Cleaning Path | 24 in |
| Power Source | Battery |
| Battery Voltage | 24V |
| Model | Viper Fang 24T |
| Voltage | 24 V |
| Brush Width | 24 in |
To Next Page
