Viper AS430B - User Manual

Other manuals for Viper AS430B

Questions and Answers

A
Anthony BowmanAug 5, 2025
What to do if Viper Scrubber has inadequate vacuum?
- J
  James BrownAug 5, 2025
  If your Viper Scrubber isn't vacuuming properly, several factors could be at play. First, check if the wastewater tank is full and drain it if necessary. Ensure the vacuum tube connecting the waste and squeegee is properly attached. Inspect the float filter for blockages and clean it, also checking the float ball. Examine the squeegee for dirt or damage to the blade, cleaning or replacing as needed. Finally, verify that the recovery tank lid is correctly sealed, and replace the water tank sealing strip if damaged.
C
Colin PriceAug 9, 2025
What to do if Viper AS430B Scrubber squeegee is leaving marks?
- J
  Jennifer MasonAug 10, 2025
  If the squeegee on your Viper Scrubber is leaving marks, start by checking for any debris trapped under the squeegee blade and remove it. If the blade is worn, cracked, or brittle, replace it. Lastly, ensure the squeegee is properly balanced and adjust if necessary.
K
Kristina BergerAug 14, 2025
Why is my Viper Scrubber brush not working?
- A
  Austin SweeneyAug 15, 2025
  If the brush on your Viper Scrubber isn't working, there are a couple of things to check. First, see if the brush fuse has tripped and reset it if needed. Also, examine the belt for slippage and adjust the tension pulley if necessary.
A
Angela HenryAug 20, 2025
How to fix pure water supply issue with Viper AS430B Scrubber brush?
- S
  Sandy DayAug 20, 2025
  If the pure water supply to the brush on your Viper Scrubber is inadequate, the filter may be dirty. Clean the filter to resolve this issue.
B
Brittany WyattAug 26, 2025
What to do if Viper Scrubber vacuum motor is not working?
- C
  Courtney BarnettAug 26, 2025
  If the vacuum motor on your Viper Scrubber isn't working, check to see if the vacuum fuse has tripped. If it has, reset it.
D
daniel80Aug 29, 2025
How to fix a Viper AS430B Scrubber that is not working and the indication light is off?
- S
  steven67Aug 29, 2025
  If your Viper Scrubber isn't working and the indication light is off, there are a couple of potential causes. Check if the battery connector is disconnected and connect it. If the battery is exhausted, charge it.

Summary

INTRODUCTION

Manual Contents

Provides necessary information for safe and proper machine use, including technical data, safety, operation, storage, maintenance, and disposal.

Scope of Application

Used for cleaning smooth, hard floors in domestic/industrial environments by qualified operators.

GENERAL SAFETY GUIDES

Safety Precautions

Adheres to manual guidance, uses only approved accessories, trained personnel, proper ventilation, and avoids hazards.

TECHNICAL DATA

Machine Specifications

Detailed specifications for AS430B and AS510B models, including dimensions, capacity, power, and weight.

MACHINE DESCRIPTION

Control Panel Overview

Details the function of each button, light, and switch on the AS430B and AS510B control panels.

INSTALLING AND SETTING THE BATTERY OF THE NEW MACHINE

Battery Installation and Type Setting

Procedures for setting the circuit board and DIP switch for WET or GEL/AGM batteries.

MACHINE START AND STOP

MACHINE OPERATION (SCRUBBING AND DRYING)

TANK EMPTYING

Recovery tank emptying

Detailed steps to drain the wastewater from the recovery tank using the drain hose.

MAINTENANCE AND CARE

Scheduled Maintenance Table

A table outlining daily, weekly, 6-monthly, and annual maintenance procedures for the machine.

Battery Charging

Instructions and precautions for charging the machine's batteries using onboard or external chargers.

SQUEEGEE CLEANING

WATER TANK AND FLOAT FILTER MESH CLEANING

CIRCUIT FIGURE OF AS430 B AND AS510 B

TROUBLESHOOTING

Problem Resolution

Lists common machine problems, their probable causes, and recommended solutions.

MACHINE DISPOSAL

Viper AS430B Specifications

General

Model	AS430B
Category	Scrubber
Voltage (V)	24
Brush motor (W)	450
Solution tank (l)	40
Recovery tank (l)	40
Scrubbing width (mm)	430
Brush diameter (mm)	430
Pad diameter (mm)	430
Brush pressure (kg)	30