11 / 120INST-007080 / E eco-CONTROL EC200 2.0
SAFETY
2.4 Informal safety precautions
The following documents must be read, understood and followed. They must always be
available at the machine's operating location, and must be kept in legible condition:
• The operation manual for this product
• Generally applicable and local accident prevention and environmental protection
regulations
• Safety data sheets for the conveyed materials, as well as for any cleaning products or
lubricants being used
2.5 Preventing damage to equipment
In order to prevent damage to equipment and to ensure precision dosing, ensure that
• the connecting cable for a dispenser may only be connected or disconnected when
the power supply is switched off. Otherwise, the electronics in the drive motor could
be damaged
• only original dosing pressure sensors adapted for the dosing control unit are to be used
• the dispenser must never be operated without material (the stator will be destroyed)
• the material inlet (feed) and the material outlet must never be closed during operation
• the material outlet (e.g. dosing needle or mixer) must not be damaged or blocked
• the dispenser is regularly checked and cleaned
• the specifications in the product data sheet for the material are observed and adhered to
To Next Page
Loading...
Need help?
General
