Need help?Do you have a question about the Vision Engineering SWIFT PRO Series and is the answer not in the manual?
General| Z-axis measurement | Yes |
|---|---|
| Illumination | LED |
| Display | External Monitor (Not Included) |
| Software | Swift-CMM |
| Measurement Software | Swift-CMM |
| Connectivity | USB |
| Field of View | Varies with magnification |
| Working Distance | Varies with objective lens |
High accuracy measurement, operation by trained personnel, and adherence to safety regulations.
Cleaning procedures, use of approved agents, and servicing by authorized personnel only.
Covers electrical, heat, illumination, environmental safety, and operator wellbeing.
Conformance to directives (WEEE, RoHS, CE) and warranty invalidation conditions.
Covers measuring stage, range, height adjustment, encoder resolution, and video camera details.
Details optics, illumination, PSU fuse ratings, and overall dimensions.
Identifies stand, lens mount, objectives, illuminators, toolkit, shield, and Z axis kit.
Illustrates the Swift PRO Cam configuration and available manual stages.
Shows the system head, QC 3000 unit, and PC controller components.
Instructions for removing and retaining transit protection screws and plate.
Steps to insert, secure lens mount, and attach objective lens.
Steps for attaching LED ringlight and episcopic illuminator.
Details on connecting the EPI lead to its connector and the focus assembly.
Steps to use levelling foot, place stage, check cleanliness, and loosely fit stage bolts.
Diagrams and notes for connecting the system to a PC and QC 3000 unit.
Procedures for aligning the stage for video systems and securing it with screws.
Instructions for positioning and connecting the head, centering alignment plate, and tightening securing screw.
Procedure for fitting the stage glass into its recess, aligning bevelled edges.
Steps to level the stage glass using axis and focus controls for all four corners.
Instructions for sliding and securing the anti-glare shield with screws and washers.
Identifies and illustrates the main system controls for axis, focus, and illumination.
Covers cleaning, checking components, environmental conditions, and optimal positioning for accuracy.
Step-by-step guide to disconnecting power, removing parts, and replacing the LED.
Instructions for fitting graticules, securing them, and adjusting focus and alignment.
Notes that Z axis module retrofitting and riser block installation require authorized service personnel.
Steps to remove the episcopic assembly and replace the LED.
Section to record system, stage, and PSU serial numbers.
Table format for logging service history, comments, dates, company, and signature.
Shows Vision Engineering's global operations, distribution network, and contact details.
To Next Page
