6
CS-1900P_manual_en.doc
AUTO STANDBY
The loudspeakers go into standby after 10 minutes of inactivity.
• Bluetooth device NOT PAIRED when it goes into standby:
o wake up when you pair a device or play audio though the line-level input.
• Bluetooth device PAIRED when it goes into standby:
o if BT input was selected: only Bluetooth source will wake them up.
o If line-level input was selected: only line-level input will wake them up.
STATUS INDICATORS
BLUE – Bluetooth input
Flashing slowly: Bluetooth is in pairing mode
On: Device paired
YELLOW – Line-level input
On: cable input selected
RED LED –Standby
Flashing slowly: mute activated
Flashing quickly: IR from remote control being received
On: in standby
To Next Page
Loading...
