MGW Ace Decoder HEVC Decoding Appliance
User Manual, Version 1.0 27
For Zixi Point-to-point channel:
Select the required protocol..
NOTE: Zixi point-to-point streaming with MGW ACE Encoder
Zixi Point-to-point license is included when MGW Ace Decoder is used in conjunction with VITEC encoders.
To start using point-to-point Zixi streaming between MGW Ace Decoder and MGW ACE encoder:
Verify that MGW ACE and Ace Decoder can communicate (gateways are properly
configured).
Set Zixi as the protocol on both MGW Ace Decoder and MGW ACE encoder.
Set the MGW ACE encoder Target Address by entering MGW Ace Decoder system
IP address (Zixi is unicast address only).
Set the same target port on both MGW Ace Decoder and MGW ACE encoder.
Start the MGW Ace Decoder by clicking Play.
For Pro-MPEG channel:
Enter a Channel Name to differentiate channels within the
Channel list. Channel name is optional.
Select the Ethernet Port from which the channel is received.
Select Pro-MPEG protocol.
Type the channel IP address.
Type the port number through where columns check sums
will be sent.
Type the port number through where rows check sums will
be sent when 2-D mode is selected.
To Next Page
Loading...
Need help?
General
