SAFETY FEATURES
4 CHAPTER 1
1.4.3 HIGH VOLTAGES
The 3 x 400 Volt supply present an electrical hazard.
High voltages are present on various parts of the system.
Hazard warning labels are places on the outside and inside of the enclosures.
• To avoid exposure to high voltages, ensure that the protective panels remain closed during
operation.
• Only qualified electricians should work on the electrical circuits of the machine.
• Before working on an electrical circuit, turn main power off and block the mainswitch with a
padlock.
• Ensure that the system is properly grounded.
1.4.4 MECHANICAL HAZARD
All moving parts of the soldering system, including pulleys, belts, chains, coolingfans, sprocket-
wheels and cylinders present a potential danger.
Be careful with covers and doors. Always pay attention to opening and closing.
• Take care not to get your hands or fingers in any moving mechanisms.
• Be mindful of long hair, neckties, bracelets and other parts that can get caught in a moving
mechanism.
• Always stop all moving parts when performing service on the machine.
ALWAYS PLACE AND CLOSE COVERS / WINDOWS BACK BEFORE
OPERATING.
1.4.5 EYE HAZARD
When working on the machine, always protect your eyes with safety glasses.
To Next Page
Loading...
