Vivint Element CT200 - Power Supply Options

Wiring
Vivint Element CT200 Installation Guide
Battery Installation
Power Supply
While the thermostat can run without batteries on C-wire power,
you should install batteries as well to provide power to the unit
during outages. See the Thermostat Battery Cautions.
1. Install four (4) AA alkaline batteries following the marked polarity
in the battery compartments. Insert the battery negative end rst
against the spring, then push the positive end in.
2. With all the wires connected and the unit attached to the wall, it
is time to turn the AC power back on. Reconnect the power at the
breaker you used to switch it o. The Thermostat will power-up in
the OFF mode.
3. Your Thermostat is not yet congured to operate your HVAC
system. You must now connect your thermostat to a Z-Wave
Network and congure the HVAC and Heat Source settings.
12