Vivint Element CT200 Operation Guide
FCC WARNING
Changes or modications to this unit not expressly approved by the
party responsible for compliance could void the user’s authority to
operate the equipment.
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful
interference to radio or television reception (which can be
determined by turning the equipment o and on), try to correct the
interference by following these suggestions:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit dierent from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
45
WARNING: Changes or modifications to this receiver not expressly approved by RTCOA void
the user’s authority to operate this equipment.
RF Exposure info -- (manual)
This equipment complies with FCC’s and IC's RF radiation exposure limits set forth for an
uncontrolled environment. The antenna(s) used for this transmitter must be installed and
operated to provide a separation distance of at least 20 cm from all persons and must not be
collocated or operating in conjunction with any other antenna or transmitter. Installers must
ensure that 20cm separation distance will be maintained between the device (excluding its
handset) and users.
To Next Page
Loading...
