Vivitek D851 - Installation Menu - Part 2; System, Lamp, and Status Configuration

DLP Projector – User’s Manual
Installation II Menu
Press the MENU button to open the OSD menu. Press the cursor ﾕﾓ button to move to the Installa-
tion II menu. Press the cursor ﾒﾔ button to move up and down in the Installation II menu.
ITEM DESCRIPTION
Auto Source Press the cursor ﾕﾓ button to enable or disable automatic source detection. (Range: On ~ Off)
Auto Power Off
(min.)
Press the cursor ﾕﾓ button to enable or disable automatic shutdown of lamp when no signal.
Auto Power On Press the cursor ﾕﾓ button to enable or disable automatic power On when AC power is supplied.
Press the cursor ﾕﾓ button to toggle between Normal and High fan speeds.
Note: We recommend selecting high speed in high temperatures, high humidity, or high
altitude areas.
Fan Speed
Press the cursor ﾕﾓ button to select the lamp mode for higher brightness or lower brightness
to save lamp life.
Lamp Mode
– 31 –
Advanced Press (Enter) / ﾓ to enter the Advanced menu. See Advanced Feature on page 32.
Factory Reset Press (Enter) / ﾓ to reset all items to factory preset values.
Status Press (Enter) / ﾓ to enter the Status menu. See page 40 for more information on Status.