7
STEP 12
STEP 13
Attach the controller to the underside of the desktop using 3/4" screws (S-C) as shown. Once controller
is installed, cable clips (S-E) can be attached to the desk for cable management. Refer to the Controller
User Guide for operational instructions.
If necessary, adjust foot pads to level desk.
CAUTION!
Failure to follow these instructions may result in property damage and/or personal injury.
Do not exceed desk
weight limit.
Keep area of vertical
motion free of
obstacles.
Keep weight on desk
balanced for correct
operation and longer
life of components.
Leave enough slack in
cables to allow for full
range of vertical motion.
To Next Page
Loading...
