VIVOTEK
User's Manual - 57
Media > Image
This section explains how to configure the image settings of the Network Camera� It is
composed of the following four columns: General settings, Picture settings, Exposure, and
Privacy mask�
General settings
Video title
Show_timestamp_and video_title_in_video_and_snapshots: Enter a name that will be displayed on
the title bar of the live video as the picture shown below�
Video Title
Title and Time
Video 17:08:56 2014/09/09
2014/09/09 17:08:56
Position of timestamp and video title on image: Select to display time stamp and video title on the
top or at the bottom of the video stream�
Timestamp and video title font size: Select the font size for the time stamp and title. Color: Select to
display color or black/white video streams�
Power line frequency: Set the power line frequency consistent with local utility settings to eliminate
image flickering associated with fluorescent lights� Note that after the power line frequency is
changed, you must disconnect and reconnect the power cord of the Network Camera in order for
the new setting to take effect�
Video orientation: Flip--vertically reect the display of the live video; Mirror--horizontally reect the
display of the live video� Select both options if the Network Camera is installed upside-down (e�g�,
on the ceiling) to correct the image orientation� Please note that if you have preset locations, those
locations will be cleared after ip/mirror setting.
To Next Page
Loading...
Need help?
General
