Vivotek FD8181 User Manual

VIVOTEK
User's Manual - 9
Hardware Reset
The reset button is used to reset the system or restore the factory default settings� Sometimes
resetting the system can return the camera to normal operation� If the system problems remain
after reset, restore the factory settings and install again�
Reset: Press and release the recessed reset button with a straightened paper clip. Wait for the
Network Camera to reboot�
Restore: Press and hold the recessed reset button until the status LED rapidly blinks. Note that
all settings will be restored to factory default� Upon successful restore, the status LED will blink
green and red during normal operation�
Micro SD/SDHC/SDXC Card Capacity
This network camera is compliant with Micro SD/SDHC/SDXC 8/16/32/64GB and other
preceding standard SD cards�
Recessed Reset
Button
LED Denitions
Item LED status Description Priority
LED De`nitions
1 Steady Red Powered and system booting 3
Red LED off Power off
2 Steady Red Network failed 2
Red
LED blinks every 1 sec� (on for
1 sec� and off for antoher)
Connected to network (heartbeat) and BRB
mode (Back Recovery Booting)
3 Blinks RED
every 0�15 sec� (on for
0�15 sec� and off for another)
Upgrading rmware. 1
4 Blinks RED
every 0�15 sec� (on for
0�15 sec� and off for another)
Restoring defaults� 1

Vivotek FD8181 Specifications

General

Brand	Vivotek
Model	FD8181
Category	Security Camera
Language	English