Vivotek IP7361 - Page 132

VIVOTEK
132 - User's Manual
5.10 IR Cut Control
Group: ircutcontrol
NAME VALUE SECURITY
(get/set)
DESCRIPTION
mode auto, day, night, di,
schedule
6/6 Set IR cut control mode
daymodebegintime 00:00~23:59 6/6 Day mode begin time
daymodeendtime 00:00~23:59 6/6 Day mod end time
disableirled <boolean> 6/6 Enable/disable IR led
bwmode <boolean> 6/6 Switch to B/W in night mode if enabled
sensitivity low, normal, high 6/6 Sensitivity of light sensor
5.11 Image Setting per Channel
Group: image_c<0~(n-1)> for n channel products
NAME VALUE SECURITY
(get/set)
DESCRIPTION
brightness <product
dependent>
4/4 Adjust brightness of image according to mode
settings.
saturation -5 ~ 5 4/4 Adjust saturation of image according to mode settings.
contrast -5 ~ 5 4/4 Adjust contrast of image according to mode settings.
sharpness <product
dependent>
4/4 Adjust sharpness of image according to mode settings.
IBPE_edgeenable <boolean> 4/4 Enable edge enhancement.(Haydn only)
IBPE_edgestrength 1 ~ 128 4/4 Adjust edge enhancement strength. 1 is minimum and
128 is maximum. (Haydn only)
IBPE_nrenable <boolean> 4/4 Enable noise reduction. (Haydn only)
IBPE_nrmode 1 ~ 3 4/4 Adjust noise reduction mode.
1 => DeGaussian
2 => DeImpulse
3 => DeGaussian + DeImpulse
(Haydn only)
IBPE_nrstrength 1 ~ 63 4/4 Adjust noise reduction strength. 1 is minimum and 63
is maximum. (Haydn only)