Vivotek IP7361 - Camera Ptz Control

VIVOTEK
User's Manual - 137
3: LOG_ERR
4: LOG_WARNING
5: LOG_NOTICE
6: LOG_INFO
7: LOG_DEBUG
5.21 Camera PTZ Control
Group: camctrl (product dependent)
NAME VALUE SECURITY
(get/set)
DESCRIPTION
enablehttptunnel <boolean> 4/4 Enable HTTP tunnel for camera control.
Group: camctrl_c<0~(n-1)> for n channel product (capability.ptzenabled)
NAME VALUE SECURITY
(get/set)
DESCRIPTION
panspeed -5 ~ 5 1/4 Pan speed
tiltspeed -5 ~ 5 1/4 Tilt speed
zoomspeed -5 ~ 5 1/4 Zoom speed
autospeed -5 ~ 5 1/4 Auto pan speed
focusspeed -5 ~ 5 1/4 Auto focus speed
preset_i<0~(npre
set-1)>_name
string[40] 1/4 Name of the preset location.
uart 0 ~ (m-1), m is UART
count
1/4 Select corresponding uart (capability.nuart>0).
cameraid 0~255 1/4 Camera ID controlling external PTZ camera.
isptz 0 ~ 2 1/7 0: disable PTZ commands.
1: enable PTZ commands with PTZ driver.
2: enable PTZ commands with UART tunnel.
disablemdonptz <boolean> 1/4 Disable motion detection on PTZ operation.
patrolseq string[64] 1/4 (For external device) The indexes of patrol
points, separated by “,”
patroldwelling string[128] 1/4 (For external device) The dwelling time of each
patrol point, separated by “,”