VIVOTEK
84 - User's Manual
PTZ > PTZ settings
Advanced Mode
This section explains how to control the Network Camera’s Pan/Tilt/Zoom operation� This panel
provides the access to two conguration choices: Digital and mechanical PTZ. The e-PTZ works
only when a streaming view is not showing the full of the camera’s largest frame size. For
example, when showing a 640x400 frame out of the 1280x800 full frame�
Digital: Control the e-PTZ operation� It allows users to quickly move the focus to a pre-
congured target area for close-up viewing without physically zooming the camera.
Digital PTZ Operation (E-PTZ Operation)
If you select “Digital“, the e-PTZ control settings section will be displayed as shown below:
Select stream: You can only apply e-PTZ control on stream #1. Refer to the following page for details
about how to set up preset and patrol settings
�
Auto pan/patrol speed: Select the speed from 1~5 (slow/fast) to set up the Auto pan/patrol speed control�
When completed with the settings of e-PTZ, click Save to enable the settings on this page�
2010/12/10 17:08:56
To Next Page
Loading...
