EasyManuals Logo

Vivotek SD8362E User Manual

Vivotek SD8362E
192 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #105 background imageLoading...
Page #105 background image
VIVOTEK
User's Manual - 105
If you enable adaptive recording and enable time-shift cache stream on Camera A, only when an event
is triggered on Camera A will the server record the full frame rate streaming data; otherwise, it will only
request the I frame data during normal monitoring, thus effectively save lots of bandwidths and storage.
The alarm trigger includes: motion detection and DI detection. Please refer to Event settings on page 85.
■ Pre-event recording and post-event recording
The Network Camera has a buffer area; it temporarily holds data up to a certain limit. Enter a number
to decide the duration of recording before and after a trigger is activated.
■ Priority: Select the relative importance of this recording (High, Normal, or Low). Recording with a higher
priority setting will be executed rst.
■ Source: Select a stream for the recording source.
To enable adaptive recording, please also enable time shift caching stream and select a caching
stream on Media > Video > Stream settings. Please refer to page 77 for detailed instruction.
► To enable recording notication please congure Event settings rst. Please refer to page 85.
Please follow the steps 1~2 below to set up the recording:
1. Trigger
Select a trigger source.
■ Schedule: The server will start to record les on the local storage or network storage (NAS).
■ Network fail: Since network fail, the server will start to record les on the local storage (SD card).
Time
Bandwidth
Bandwidth
Activity Adaptive Streaming
for Dynamic Frame Rate Control
I frame ---> Full frame rate ---> I frame
Continuous recording
To enable adaptive recording, please make sure
you’ve set up the trigger source such as Motion
Detection, DI Device, Audio detection, or Manual
Trigger.
When there is no alarm trigger:
- JPEG mode: record 1 frame per second.
- H.264 mode: record I frame only.
- MPEG-4 mode: record I frame only.
When the I frame period is >1s on Video settings
page, it should be forced to make the I frame period
to 1s when adaptive recording is activated.
NOTE:
NOTE:

Table of Contents

Other manuals for Vivotek SD8362E

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Vivotek SD8362E and is the answer not in the manual?

Vivotek SD8362E Specifications

General IconGeneral
BrandVivotek
ModelSD8362E
CategorySecurity Camera
LanguageEnglish

Related product manuals