6 7
SAFETY INSTRUCTIONS SAFETY INSTRUCTIONS
1.3.2 TRANSPORTATION
ATTENTION Denting of the probe or base unit:
Possible damage of the device or components
• always transport the device and accessories in the transport case designed
by the manufacturer
ATTENTION Tensile load of probe or cable
Possible damage of the device or components
• do not move the device by pulling probe or cable
1.3.3 PUTTING INTO SERVICE
WARNING Electric shock:
Can cause physical damage or even death
• operation only with proper PE (protective earth) connection to application
or protective earth
• operation only on AC voltage system of 100-240 VAC / 50-60Hz
• The use of a residual current circuit breaker (according to DIN VDE 0100-
701:2008-10 or DIN VDE 0100-410:2018-10) or an isolating transformer is
mandatory during mains operation
• only connect to sockets with a ground conductor
• do not use extension cables longer than 25 meters
• only inspect applications and surroundings that are not under electrical
voltage
• only operate the device with its housing closed
• check the probe externally for damage before using it
WARNING Water from the water separator:
Risk of poisoning
• check the probe externally for damage before using it
CAUTION Damaged probe coating:
Risk of cutting injuries
• check the probe externally for damage before using it
• always wear protective gloves to prevent possible injuries
To Next Page