Vizio VW32LHDTV40A - TV and Stand Base Assembly

VIZIO
®
VW32L HDTV40A User Manual
Version 10/17/2008 65
www.VIZIO.com
4.2 TV and Stand Base Assembly
If the original instructions had been misplaced or lost, the following steps are a duplicate of such
document, removing the Stand Base may be the only steps to be done at this point.
NOTE: It is strongly recommended that two people perform the setup and assembly due to the
weight and size of the TV.
To unpack the TV and stand base
The following steps are required to assemble the two parts:
StandNeck
1. Remove the remote control, batteries, and power
cord from the foam end caps.
2. Remove the two top foam end caps.
3. Remove the stand base under foam end cap.
4. Remove the TV from the box and lay it face down on a clean, flat surface.
Note: Make sure that the surface is free of debris to prevent the TV screen from getting scratched
.
StandBase 

ToattachtheTVstandbase:
1.Lineupthearrowsonthestandneck(attached
totheTV)withthearrowsonthestandbase.
2.Pushthestandbaseontothestandneckuntil
youhearthemclicktoget her.
3.On the bottom of the base, insert the four
includedscrewsandtight
enthemup.
4.MovetheTVintoanuprightposition.

Toremovethestandbase 
1. Removethefourscrewsfromthestandbase.
2. Pullthestandbaseawayfromthestandneck.
