To Next Page

To Previous Page

VlZlOVX32LHDTV10AUserManual

Chapter 3 Se ioq Up to Watch TeLevision

For 'Preparing Your LCD HDTV for Wall Mounting', see page 5.

3,1 Basic LCD HDTU Start Up

Connecting the Power Cable

Connect the power cord to the power cord connector on the back of the HDTV, and then plug the

power cord into an AC wall socket.

Connect Audio and Video Cables to the HDTV

(see pages 13 ~ 22 for detailed steps)

Turning Power On

Once all the components are connected, press the Power ON button on the side of the HDTV, or

press the Power ON (Red) button on the remote control.

Select Input Source

Select the Input Source for the HDTV by pressing the INPUT

button on the side of the TV or using the Input button on the

remote control. Pressing this button will cycle you through the

following options: TV, AV1, AV2, Component1, Component2,

RGB, HDMI1 and HDMI2.

Using DTV and TV with an Antenna or Cable

At first power on, the HDTV will have the DTV/TV input selected

and will guide through some setup screens. If it is not the first

time the HDTV has been powered on, you will need to select TV

using the INPUT button on the remote control or the side of the

HDTV, or directly by pressing the TV button on the remote

control, and Auto Scan for the available TV channels.

a. The screen will show 'snow' and

the first Initial Setup OSD panel.

Press the OK button on the

remote control.

Version 3/13/2007 24

Vizio VX32LHDTV10A User Manual

Questions and Answers: