– Position engine support - T40074- on engine as shown and
retighten adapter - T40074/1- with engine support - T40074-
-2-.
– Fit engine support - T40074- with M10x25 bolts on exhaust
side as shown and tighten to approx. 20 Nm on cylinder block
-arrows-.
– Lift engine and gearbox slightly using engine and gearbox jack
- V.A.G 1383 A- .
– Unbolt engine side of assembly mounting from engine bracket
from above -arrows-.
– Unbolt gearbox side of assembly mounting from gearbox
bracket -arrows- from above.
Note
♦
To remove securing bolts use a stepladder - VAS 5085- .
♦
Engine with gearbox must be guided carefully when lowering
to prevent damage to bodywork.
– Carefully lower engine with gearbox.
1.2 Separating engine and gearbox
Condition
• For vehicles with automatic gearbox the work procedure may
vary slightly.
• Engine with gearbox removed and secured on engine bracket
- T10359- .
CC 2012 ➤ , Passat 2011 ➤ , Passat Variant 2011 ➤
6-cylinder direct-injection engine (3.6 l engine, 4V) - Edition 06.2019
1. Removing and installing engine 15
To Next Page
Loading...
Need help?
General
