Renewing engine oil filter, engine codes CJDA, CJDD, CPYA,
CPYB, CPYC, CPYD, CPYE ⇒ Page 246.
Fill engine oil ⇒ Page 247.
● The engine oil must be changed regularly as per the specifi-
cations in the service schedule.
● The engine oil and filter change should always be carried out
in a specialist workshop as special tools and knowledge are
required. This also applies to the disposal of used oil. Volks-
wagen recommends that these tasks are carried out at a
Volkswagen dealership.
● Additives in the engine oil can cause new engine oil to dis-
colour quickly. This is normal and does not mean that the
engine oil should be changed more frequently.
1.2.1 Draining or extracting engine oil
Caution
◆ For engines with upright oil filter module, the oil filter
should be renewed before changing the engine oil.
When removing the filter element a valve is opened, the
oil in the filter housing automatically flows into crank-
case.
◆ The oil drain plug is fitted with a captive seal. Therefore,
the oil drain plug must always be renewed.
Special tools and workshop equipment required
◆ Used oil collection and extraction unit -V.A.G 1782-
◆ Cloth to absorb oil -VAS 6204/1-
Draining or extracting engine oil:
Carry out the following procedure:
– Extract engine oil using used oil collection and extraction
unit -V.A.G 1782-.
Or
– Remove oil drain plug.
– Let engine oil drain.
Note
Use a suitable container when draining the used oil. It must be
at least large enough to hold the entire quantity of engine oil re-
quired for refilling.
– Screw in oil drain plug together with seal hand-tight and then
tighten to specified torque.
– Fill engine oil, specification ⇒ Page 247.
Engine oil capacity: ⇒ Page 247.
Specified torques for oil drain plug:
Industriemotoren - Industrial Engines 2009 ▶
Workshop Manual for Diesel Engine (2.0 l/36-75 kW_EA 189) 05.2015
3
1 Engine oil
245
To Next Page
Loading...
