Caution
♦ Switch off ignition and all electrical consumers.
♦ Remove the ignition key.
♦ When removing and installing components that are in view
(switches, covers, trim), mask off areas where tools ( re‐
moval wedge -VAS 3409- , screwdriver) are used to lever
out those components using commercially available
masking tape.
Removing
– Remove door trim ⇒ General body repairs, interior; Rep. gr.
70 .
– Disconnect connector -arrow-.
– Release locking lugs -arrows- and remove remote release
button for fuel filler flap and rear lid -E463- from door trim pan‐
el.
Installing
Installation is carried out in reverse order of removal.
3.7 Removing and installing interior moni‐
toring/vehicle inclination deactivation
switch
The interior monitoring deactivation switch -E267- / deactivation
button for vehicle inclination sender -E360- are combined in one
unit and installed in trim of B-pillar at bottom.
The shape of the switch has been changed from model year 2007
onwards.
Special tools and workshop equipment required
Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤
Electrical system - Edition 07.2010
3. Lights and switches in front doors and B-pillar 397