♦ 01 - On Board Diagnosis capable systems
♦ Convenience system
♦ Functions of convenience system central control unit
♦ Read alarm sources of anti-theft alarm
5.4 Driver door control unit -J386-
General description
The driver door control unit -J386- and the driver side window
regulator motor -V147- are contained in one unit and cannot be
replaced individually.
If the driver door control unit -J386- or the driver side window reg‐
ulator motor -V147- are replaced, then the work procedure „Cod‐
ing driver door control unit“ must be subsequently performed
⇒ page 477 .
Additional information:
⇒ Current flow diagrams, Electrical fault finding and Fitting loca‐
tions
⇒ Operating manual
5.4.1 Removing and installing driver door con‐
trol unit -J386-
Removing and installing driver door control unit -J386- ⇒ General
body repairs, exterior; Rep. gr. 64 .
Note
If the driver door control unit -J386- or the driver side window reg‐
ulator motor -V147- are replaced, then the work procedure „Cod‐
ing driver door control unit“ must be subsequently performed
⇒ page 477 .
5.4.2 Coding driver door control unit -J386-
Special tools and workshop equipment required
♦ Vehicle diagnosis, testing and information system -VAS
5051B-
Procedure
– Connect vehicle diagnosis, testing and information system -
VAS 5051B- .
– In vehicle diagnosis, testing and information system -VAS
5051B- , select „Guided fault finding“.
– Using GoTo button, select „Functions/component“ and the fol‐
lowing menu options in succession:
Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤
Electrical system - Edition 07.2010
5. Control units 477