33
• Change the discharging current using the button "INC" or "DEC". Keep the respective button pressed for quick
adjustment.
Briey push the "START/ENTER" button to conrm the set discharging current.
• When no display is ashing anymore, keep the "START/ENTER" button pushed (approx. 3 seconds), to start
discharging.
If the settings are wrong, or if the charger detects a problem, an audio signal is emitted and the appropriate
information is shown on the display. You can stop the warning signal by pressing the "BATT. TYPE/STOP"
button. The charger then returns to the previous conguration menu.
The display shows, e.g., the following data while discharging:
The rechargeable battery type is shown in the upper left ("P" = lead bat-
tery), the upper middle shows the discharging current and the upper right
the current rechargeable battery voltage.
The lower left shows the current rechargeable battery programme ("DSC" = "DISCHARGE"), in the middle the
elapsed charging time and the charged capacity in mAh are displayed to the right of this.
• Once the discharging process has been completed, an audio signal is emitted (if it was not turned off).
If you wish to cancel the discharging process, push the "BATT. TYPE/STOP" button.
P-6 1.0A 12.32V
DSC 022:45 00690
To Next Page
Loading...
