VOLTCRAFT V-CHARGE 50 - c) Loading Battery Data

38
c) Loading Battery Data
• Select the function "BATT MEMORY" in the main menu of the charger with
the button "INC" or "DEC".
• Conrm the selection by pressing the "START/ENTER" button. The
memory number ashes.
• Select one of the 10 memories with the buttons "INC" or "DEC".
If there are data in the memory, the display will show in the bottom
line alternately, e.g., the rechargeable battery type and the cell
number, as well as the charging and discharging current.
When the memory is empty, the bottom line shows only the informa-
tion "ENTER SET ->".
• Load the battery data from the selected memory by pushing the button
"START/ENTER" for 3 seconds.
The display shows the message "ENTER CHARGE LOAD....."; the data
are then loaded and the desired charging/discharging programme can then
be started (push the button "START/ENTER" again for 3 seconds).
If you keep the button "START/ENTER" pushed for 3 seconds in an empty memory, the charger will start
selection/setting mode, see chapter 14. a).
PROGRAM SELECT
BATT MEMORY
[ BATT MEMORY 1]
LiPo 7.4V(2S)
[ BATT MEMORY 2]
ENTER SET->
ENTER CHARGE
LOAD...