Why is there no measured value change on my VOLTCRAFT Multimeter?
If your VOLTCRAFT Multimeter shows no measured value change, first check if the correct measuring function (AC/DC) is activated by looking at the display and switching the function if needed. Also, verify that you're using the correct measuring jacks and that the measuring lines are properly seated. Finally, make sure the Hold function is deactivated.
What to do if no measurement is possible in the A measurement range of my VOLTCRAFT Multimeter?
If your VOLTCRAFT Multimeter isn't measuring current in the A range, the fuse for the A measuring range might be defective. Check the 11 A fuse F2.
Why can't I measure in the mA/µA measurement range on my VOLTCRAFT Multimeter?
If your VOLTCRAFT Multimeter isn't measuring current in the mA/µA range, the fuse for that range might be defective. Check the 600 mA fuse F1.
General| Type | Digital Multimeter |
|---|---|
| Model | VC-450 E |
| Display | LCD |
| DC Voltage Range | 200mV - 600V |
| AC Voltage Range | 200V - 600V |
| Safety Standard | CAT III 600V |
| Power Supply | 9V Battery |
| Depth | 35 mm |
| Basic Accuracy | 0.5% |
| DC Current Range | 200μA - 10A |
| AC Current Range | 200 µA - 10 A |
| Frequency Range | 1Hz - 10MHz |
| Temperature Range | -40°C to 1000°C |
To Next Page
