Power Take-off
Engines can be disconnected as a propulsion unit for
use as a power take-off.
The function can only be activated from an active
station. It is possible to change engine speed and
disconnect the function from an inactive helm station.
Engaging the power take-off
1 Move the control levers to neutral.
2 Press PTO to disconnect the midships engine from
propulsion. The engine is now locked in neutral at
idle revolutions and cannot be affected by the
control levers.
3 Use + and – to increase or reduce midship engine
speed. The engine should always be running at idle
revolutions when activating power take-off.
Engine speed can be adjusted both before and after
activation of power take-off.
4 Activate power take-off by pressing RPM.
The engine will assume the set speed.
Disengaging the power take-off
1 Press RPM to disconnect power take-off control.
The engine will revert to idle speed.
2 Move the control levers to neutral.
3 Press PTO to connect the engine for propulsion.
The engine is now in neutral and idling.
Optional
84 47712786 11-2022 © AB VOLVO PENTA
To Next Page
Loading...
