95
Laying up/Launching
Bringing out of storage
L Check oil level in the engine and drive/reverse
gear. Top up if necessary. If there is inhibiting oil
in the system drain and fill with new oil, change oil
filter. For correct oil grade: See the chapter “Tech-
nical Data”.
L Drain the antifreeze from the seawater system.
L Install the impeller in the seawater pump. Replace
if the old one looks worn. Please refer to the Sea
Water System chapter.
L Close/tighten drain cocks/plugs.
L Check the tension and condition of the drive belts.
L Check the condition of rubber hoses and tighten
hose clamps.
L Check engine coolant level and antifreeze protec-
tion. Top up if necessary.
L Connect the fully charged batteries.
L Paint the drive and hull: See next page.
L Check the sacrificial anode on the drive. If there is
less than 2/3 of the anode left it must be replaced.
Clean with emery cloth just before the boat is
launched.
IMPORTANT! Do not use a wire brush or other
steel tools when cleaning, as these may dam-
age the galvanic protection.
L Install propellers.
L Launch the boat. Check for leaks.
L Vent and lubricate the propeller shaft seal (reverse
gear).
L Start the engine. Check that there are no fuel,
engine coolant or exhaust gas leaks and that all
control functions are operating.
To Next Page
Loading...
