Tying down machine
NOTE!
On the rear part of upper frame, tie down devices
must not be in contact with surrounding structural
parts (pillars, hoods or other parts of the upper
frame). If there is interference, use another device
or change the tie down configuration.
NOTE!
For rail, maritime or container transportation, in
addition to tying down devices, using blocks to
restrain the machine is mandatory.
NOTE!
Depending on the transportation trailer geometry
and on tying down points configuration, it may not
be possible to fulfill the angles requirements. In this
case, please refer to generic rules for cargo
transportation (EN 12195).
To Next Page
Loading...
