03 Planning your trip
Specify a destination
03
40
Address
Set destination Address
There are several different ways to program a
destination.
It is sufficient to simply specify a district/city
and start the journey - it leads to the centre of
the district/city.
If a destination's latitude and longitude are
known then these can be entered.
See page 26 for information on how characters
are written/entered into the system's various
text fields.
NOTE
The definition of city or area can vary from
country to country, and also within the same
country. In some cases a metropolitan area
is indicated - in others an individual suburb.
City or street
The cursor first rests on Street.
How to search and locate a destination:
1. With the previous image view on the dis-
play screen - Press OK to activate the pre-
set text box.
2.
Enter the street's name
Street: with the
"daisy wheel" (see page 26) and then
select a desired
City:.
3.
Or
City: + OK and start by entering it.
The following search criteria can be used:
•
Area: - Enter a country.
•
City: - Enter a district/city.
•
Postcode: - Under City: the search can
also be made using a post code.
•
Street: - Enter the street address.
•
Number: - Select one of the street's house
numbers.
•
Junction: - Select a destination based on
where the two streets/roads intersect.
•
Set single destination - Deletes any des-
tinations in the itinerary and starts guid-
ance to the current destination.
•
Add as waypoint - Select + OK to add the
address to the itinerary.
•
Information - Select + OK to view infor-
mation about the selected destination.
To Next Page
Loading...
