Ceramic Master E10 en v2 11
ATTENTION!
Values of the parameters FIRE RATE, FIRE TEMP и FIRE
TIME can be changed during the execution of the
program. This can be done with the buttons PROG, ESC
and and with the turning of the multifunctional knob
MFRK.
If you press the button PROG during the execution of a
program the value of the parameter FIRE RATE will blink
on the display and with MFRK will be able to change the
programmed value.
Button ESC changes parameter FIRE TEMP, and button
changes parameter FIRE TIME.
When programming the temperature conditions for
parameters IDLE TEMP, DRY TEMP and FIRE TEMP the
program temperature cannot be lower than this of the
previous parameter and at the same time higher than
this of the next parameter.
There is a possibility for fast changing of parameters
which have TEMPERATURE and TIME dimensions. When
you push the button and rotate the MFRK the value
will change by 100 points, and by pushing and rotate
the MFRK the value will change by 10 points.
To Next Page
Loading...