VOP CeramicMaster E10 - Exchange of Data and Programs Between the Furnace and PC; Transfer of Programs from PC to Furnace

Ceramic Master E10 en v2 14
8. EXCHANGE OF DATA AND PROGRAMS BETWEEN
THE Ceramic Master E10 FURNACE AND PC.
Transfer of programs from PC to the Ceramic Master
E10 furnace.
Switch off the furnace; keep the buttons RUN and STOP
depressed simultaneously and switch on the power
supply.
Wait to appear message:
TERMO CORRECT: - - - -
Press the STOP button.
On the display following message will appear:
STOP SOUND: YES (N0)
Press ESC button.
Following question will appear:
Programs <- PC?
The furnace prompts to enter data from the PC to the
furnace. If no entering of data is needed then press the
ESC button. If entering of data is needed then start the
program Teraterm Pro on the PC.
Go to menu SETUP/Serial Port in this program and
perform following settings:
Com x - Serial port number
Baud Rate - 9600
Data - 8 bit
Parity - none
Stop - 1 bit
Flow Control - none
Transmit Delay - 0ns 1000ms
Enter the menu File/Send File and perform following
settings:
Options - select binary
Enter the file name where the programs are to be
loaded from.
Press the PROG button of the furnace.
Select the function Open from the PC.
A message on the furnace display will appear:
RECEIVING
Programs – xx
This means that the programs are being loaded
currently.
After finishing following question will appear on the
display of the furnace:
Programs -> PC?
Push the ESC button .
Following question on the furnace display will appear:
Log File to PC?
Press the ESC button.