5
VORONDESIGN.COM
INTRODUCTION
PRINT GUIDELINES
PRINT IT FORWARD
Often times our community members have issues printing ABS will bootstrap themselves into a VORON using our Print It Forward
program. This is a service where approved members with VORON printers can make you a functional set of parts to get your own machine
up and running. Check Discord if you have any interest in having someone help you out.
The Voron Team has provided the following print guidelines for you to follow in order to have the best chance at success with your
parts. There are often questions about substituting materials or changing printing standards, but we recommend you follow these
recommendations as closely as possible.
FDM MATERIAL
VORON printers are ABS capable machines that
run at impressive print speeds. For that reason we
recommend only using ABS to build your printer.
LAYER HEIGHT
Recommended: 0.2mm
EXTRUSION WIDTH
Recommended: Forced 0.4mm
INFILL PERCENTAGE
Recommended: 40%
INFILL TYPE
Grid, Gyroid, Honeycomb, Triangle or Cubic
WALL COUNT
Recommended: 4
SOLID TOP/BOTTOM LAYERS
Recommended: 5
SUPPORTS REQUIRED
None at all.
To Next Page
Loading...
