7 6
RANGER
®
13 0 0
LASER RANGEFINDER
Mode Selection
Your Ranger
®
1300 is factory
set to the angle compensating
HCD mode, yards, and medium
brightness. For most users, these
are the preferred settings.
To change modes, after the
Ranger
®
1300 is powered up
activate the Mode Selection by
pressing and holding the Menu
button for at least four seconds.
Once the Mode Selection screen
displays, release the button.
As you progress through Mode
Selection, you may exit at any
time and save your settings by
pressing and holding the Menu
button for at least four seconds—
the Ranger
®
1300 will then
return to power-up condition.
Set and Save Mode Selections in 3 Steps
1. Choose between the HCD
and LOS Modes.
After activating the
Mode Selection, press
the Measure button to
toggle between the HCD
and LOS displays. Press
the Menu button to save
your desired choice and
move to the Yards/Meters
selection screen.
2. Choose between Yards
and Meters Display. Press
the Measure button to
toggle between the Yards
and Meters display. Press
the Menu button to save
your desired choice and
move to the Brightness
selection screen.
Mode Selection
Display
Use the
Measure
button
to toggle
through
each Mode
Selection
option.
Use the Menu button
to activate the Mode
Selection displays.
Choose Between Yards and Meters
Choose Between HCD and LOS
To Next Page
Loading...
Need help?
General
