What to do if Vorwerk Vacuum Cleaner doesn't work after roller brush replacement?
After replacing the roller brush, if the Vorwerk vacuum cleaner isn't working, the roller brushes may not be correctly inserted (ensure they are precisely positioned on the drive shafts) or the electric brush may not be properly connected to the cordless vacuum cleaner (check the connection).
Why won't my Vorwerk Ultrasonic Jewelry Cleaner turn on?
Your Vorwerk Ultrasonic Jewelry Cleaner might not be turning on for several reasons. It could be in transport mode (as delivered), so try charging it. The battery pack might be empty, so charging it is recommended. Ensure the charger is correctly connected; a pulsating indicator confirms charging. Also, verify the battery pack is correctly inserted. Finally, disconnect the cleaner from the charger, as it won't start while connected.
What to do if the LED display lights up yellow on my Vorwerk Ultrasonic Jewelry Cleaner?
If the LED display on your Vorwerk Ultrasonic Jewelry Cleaner lights up yellow, it could be due to several reasons: the filter bag might be full, so you should insert a new one; the item you are cleaning might be too dense, so try cleaning a different item and check the LED display again; or the suction channels may be blocked, so you should check and clean them.
Why is my Vorwerk Ultrasonic Jewelry Cleaner Kobold electric brush so loud?
If your Vorwerk Ultrasonic Jewelry Cleaner's electric brush is too loud, consider these possibilities: the roller brushes might not be correctly inserted, so check their placement; non-original Kobold accessories could cause noise and damage, so use only original Kobold roller brushes; or an object might be stuck in the roller brush area, so remove any obstructions.
Why is the LED display flashing red on my Vorwerk Ultrasonic Jewelry Cleaner?
The LED display on your Vorwerk Ultrasonic Jewelry Cleaner might flash red due to high temperatures slowing down the charging process. Avoid charging the device in direct sunlight. Charging may also take longer after intensive use or at high temperatures. The charging process can be accelerated by removing the battery pack from the device and charging it directly on the AC charger.
How to fix a Vorwerk Ultrasonic Jewelry Cleaner electric brush that is not vacuuming properly?
If the electric brush on your Vorwerk Ultrasonic Jewelry Cleaner isn't vacuuming properly, the suction duct of the electric brush may be blocked. Open the inspection flap on the underside of the electric brush, remove the blockage, and then put the inspection flap back on.
General| Model | EBB100 |
|---|---|
| Brand | Vorwerk Kobold |
| Charging Time | approximately 4 hours |
| Filtration System | HEPA Filter |
| Cord Length | Cordless |
| Compatibility | Vorwerk Kobold |
| Filter Type | HEPA |
Instructions for first-time use and manual retention.
Explanation of symbols used in the manual for warnings and information.
Defines the proper usage of the cordless vacuum cleaner and accessories.
Details risks of electric shock, explosion, fire, and injury during operation.
Explains warning symbols and signal words indicating hazard levels.
Guide on how to connect and disconnect the electric brush accessory.
Instructions for placing the device in standby and power modes.
Details on how to park the device safely when not in use or during breaks.
Explanation of how to switch the device from standby to active use.
How to interpret LED indicators for battery status while the device is on.
Step-by-step guide to charge the cordless vacuum cleaner.
Understanding LED indicators for battery charging status.
Instructions for powering the vacuum cleaner on and off.
How to adjust the suction power using the silver switch on the handle.
Detailed instructions for using the electric brush on different floor types.
Explanation of Normal, Turbo, and Brushes deactivated modes.
How to change the operating mode of the electric brush using the foot switch.
Guidelines for effective and safe vacuuming with the electric brush.
Adjusting the brush settings for different cleaning needs.
How to activate transport mode for safe movement of the vacuum cleaner.
Instructions on how to change the premium filter bag when the LED indicates it.
Guide to cleaning or replacing the motor protection filter.
Steps for removing and replacing the integrated lithium-ion battery pack.
Instructions for charging the battery pack separately from the device.
How to inspect and clean the underside and roller brushes of the electric brush.
Procedure for removing and replacing the roller brushes on the electric brush.
Common issues and solutions for the main vacuum cleaner unit.
Troubleshooting specific problems related to the electric brush accessory.
Legal requirements and options for disposing of the electrical device.
Safe disposal procedures for the lithium-ion battery pack.
Methods for responsibly disposing of the product's packaging.
Vorwerk's commitment to environmental protection in production and materials.
To Next Page
