EasyManua.ls Logo

Vorwerk KOBOLD VK200 - User Manual

Vorwerk KOBOLD VK200
109 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
INSTRUCTION MANUAL
KOBOLD VK200
UPRIGHT VACUUM CLEANER
AND ACCESSORIES

Table of Contents

Questions and Answers

  • L
    Laura GoodwinSep 23, 2025
    What to do if the wings of the Flexo Nozzle of Vorwerk Vacuum Cleaner are unhooked?
    • J
      James WilliamsSep 23, 2025
      Reattach the wings.
  • M
    Melissa CarterAug 23, 2025
    What to do if my Vorwerk KOBOLD VK200 Vacuum Cleaner doesn’t run and the LEDs flash red?
    • D
      Daniel BoyerAug 23, 2025
      If your Vorwerk Vacuum Cleaner doesn’t run and the LEDs flash red, it could be due to a few reasons: * The telescopic handle may not have been mounted correctly during initial setup, preventing electrical connection. In this case, pull out the mains plug and extend the handle again until it locks into place. * The device may have overheated. Pull out the mains plug, let the device cool down, and try again.
  • D
    Donna LopezAug 25, 2025
    Why does my Vorwerk Vacuum Cleaner release an unpleasant odor?
    • B
      Brian MartinAug 26, 2025
      If your Vorwerk Vacuum Cleaner is releasing an unpleasant odor, the 3in1 Premium Filterbag FP200 may have lost its ability to retain odors, even if it's not full. To resolve this, replace the 3in1 Premium Filterbag and insert a new Dovina fragrance chip. Additionally, thoroughly clean the suction channel of the vacuum cleaner and any connected devices, as well as the motor protection filter.
  • C
    Chad SmithAug 26, 2025
    Why is the Automatic Electric Brush of my Vorwerk KOBOLD VK200 hard to push?
    • S
      Shannon BraunAug 27, 2025
      If the Automatic Electric Brush is hard to push, it could be due to the power performance level being too high. Try setting the device to a lower power performance level using the main switch on the handle of the Upright Vacuum Cleaner, or use the 'auto' power performance level. It’s also possible that the Automatic Electric Brush is in manual operating mode; switch the Upright Vacuum Cleaner off and back on again.
  • R
    Robert MaxwellAug 27, 2025
    Why does my Vorwerk Vacuum Cleaner change power levels and get louder?
    • M
      Mr. Seth Johns PhDAug 27, 2025
      If your Vorwerk Vacuum Cleaner changes power levels and gets louder, it may be overheating due to prolonged use, high ambient temperature, or a full/blocked 3in1 Premium Filterbag. Check the suction channel and any connected accessory heads for blockages, and replace the filterbag if necessary. Allow the motor to cool down. This can also occur when switching from hard floors to carpeting or when using the automatic suction power setting.
  • C
    Corey SmithSep 17, 2025
    Why does my Vorwerk DuoClean cause streaks or marks on the floor?
    • W
      walkerdavidSep 17, 2025
      If the DuoClean causes streaks or marks on the floor, the supporting feet might be touching the floor. Remove the supporting feet.
  • G
    Gregory SmithSep 14, 2025
    Why doesn't the secondary air flap of my Vorwerk close or remain closed?
    • M
      mckinneywilliamSep 14, 2025
      If the secondary air flap does not close or remain closed, the holding magnet may be dirty. Clean the surface of the magnet.
  • A
    Adam BakerSep 15, 2025
    Why are the bristles of my Vorwerk Electric Upholstery Brush deformed or matted?
    • H
      howarddesireeSep 15, 2025
      If the bristles of the Electric Upholstery Brush are deformed or matted, fringes or fabrics may have been sucked in and pulled out again. Exchange the suction nozzle.
  • M
    Michael PrestonSep 6, 2025
    Why does my Vorwerk DuoClean switch off and the 'ON' light flashes green?
    • D
      Dorothy MatthewsSep 6, 2025
      If the DuoClean switches off on its own and the operating display light “ON” flashes green, the motor may be overstrained. Switch off the Upright Vacuum Cleaner, let the motor cool down, then switch the Upright Vacuum Cleaner back on and close the secondary air flap on the DuoClean.
  • M
    Megan BoyerSep 3, 2025
    Why is the cleaning performance of my Vorwerk Carpet Freshener reduced?
    • E
      Eric AllisonSep 3, 2025
      If the cleaning performance of the Carpet Freshener is significantly reduced, there may be cleaning residue from a previous carpet cleaning in the device, preventing proper functioning. Clean the dosage container and brush. Also, check whether the dosage of Kobosan active was sufficient and if your carpet is suitable for cleaning with the Carpet Freshener.

Summary

For Your Safety

Hazard Warnings and Safety Notes

Covers electric shock, fire, explosion, injury, choking, pinching, improper use, and allergy-related warnings.

Danger Levels Explained

Explains the meaning of different danger level symbols and signal words used in the manual.

Getting Started

Operation

Kobold EB400 Automatic Electric Brush

Using the EB400 brush for carpets and hard floors, including intelligent floor detection.

Kobold VF200 Carpet Freshener

Cleaning carpets with the VF200 Carpet Freshener and Kobosan active.

Maintenance

VK200 Vacuum Cleaner Maintenance

Filterbag exchange, motor protection filter cleaning/exchange.

Troubleshooting

Kobold VK200 Troubleshooting

Common issues and solutions for the VK200, e.g., not running, error lights, reduced suction.

Accessory Troubleshooting

Problems and solutions for EB400, VF200, SP530, PB440, and FD15 accessories.

Technical Details

Vorwerk KOBOLD VK200 Specifications

General IconGeneral
Power Consumption700 W
Filtration SystemHEPA Filter
Cord Length10 m
Noise level78 dB
TypeUpright

Related product manuals