Vox Valveronix ToneLab LE User Manual

All LEDs light 13 AMP/LINE
All LEDs light 14 WRITE
All LEDs light 15 RENAME
All LEDs light 16 EXIT/TUNE
All LEDs light 17 GLOBAL
EDIT_PEDAL 17 GLOBAL
EDIT_AMP 17 GLOBAL
EDIT_CAB-OPTION 17 GLOBAL
EDIT_MODULATION 17 GLOBAL
EDIT_DELAY 17 GLOBAL
EDIT_REVERB 17 GLOBAL
EDIT_EXP-CTL-CHAIN 17 GLOBAL
VAULE_1(GAIN) 17 GLOBAL
VAULE_2(VR GAIN) 17 GLOBAL
VAULE_3(TREBLE) 17 GLOBAL
VAULE_4(MIDDLE) 17 GLOBAL
VAULE_5(BASS) 17 GLOBAL
VAULE_6(CH VOLUME) 17 GLOBAL
BANK_DOWN_RED 18 BANK_DOWN
BANK_UP_RED 19 BANK_UP
(Channel) 1_RED 20 (Channel) 1
(Channel) 2_RED 21 (Channel) 2
(Channel) 3_RED 22 (Channel) 3
(Channel) 4_RED 23 (Channel) 4
C0NTROL_RED 24 C0NTROL
Notice:* During check, push REVERB SELECT three times to exit the switch check and return to the
step1.
* NG occurs when detected the changing of the binary encoders (PEDAL,AMP TYPE).
Operation Check 4. Binary Encoder "BIN ENC"(LCD)
At the initial state “E1” is displayed in the BANK LED.
1. PEDAL TYPE select knob
* Adjust the knob at the top position (12:00), then rotate to clockwise.
* After one rotation and at the top position “E2” is displayed in the BANK LED.
2. AMP TYPE select knob
*Adjust the knob at the top position (12:00), then rotate to clockwise.
Notice:
*After started this check, when a switch pushed, the check stops and “SL” is displayed in
the BANK LED.
Operation Check 5. Volume with 11 clicks "C11 KNOB"(LCD)
1. MODULATION knob (Initial display BANK LED "C1")
From the MAX (right end) click of the MODULATION SELECT knob, the check begins like following
order. When the knob is already at the right end click, move one click once and set to
the right end click again.

Vox Valveronix ToneLab LE Specifications

General

Brand	Vox
Model	Valveronix ToneLab LE
Category	Music Pedal
Language	English