Voxelab Aquila X2 - User Manual

3D Printer User Manual
Aquila X2
V1.2-20210517
Note: Each device must be tested before leaving factory. If there are some
residues in extruder or some tiny scratches on the build plate, it is normal and
won’t affect the printing quality.

Summary

Notes

Product Introduction

Equipment Parameters

Mechanism Parts

Spare Parts

Installation of Z-axis Limit Switch and Profiles

Install Z-axis Motor Kit and T-shaped Screw Rod

Install Pneumatic Joint and XE-axis Kit

Install Synchronous Belt, Extruder Kit, and Z-axis Passive Block

Install X-axis Tensioner

Install X-axis Moving Kit and Adjust Tensioners

Install Gantry Profile and Screen Kit

Install Spool Holder and Gantry Cover

Wire Connection

Bed Leveling

Preheat

Load the Filament

Start Printing

Wiring Connection Diagram

Printing Notice

Troubleshooting

After-sales Service

After-sales Service Registration Form

Form for registering the printer for after-sales service and support.

Voxelab Aquila X2 Specifications