Need help?Do you have a question about the Voxelab Aquila and is the answer not in the manual?
General| Build Volume | 220 x 220 x 250 mm |
|---|---|
| Layer Resolution | 0.1-0.4 mm |
| Nozzle Diameter | 0.4 mm |
| Filament Diameter | 1.75 mm |
| Connectivity | USB, SD card |
| Supported Materials | PLA, ABS, PETG |
| Bed Temperature | up to 100°C |
| Technology | FDM (Fused Deposition Modeling) |
| Display | LCD screen |
| Nozzle Temperature | ≤250℃ |
| Power Supply | 24V, 360W |
| Frame Material | Aluminum |
Install the Z-axis limit switch kit and the Z-axis profiles onto the printer base.
Connect the Z-axis motor kit and attach the T-shaped screw rod to the motor component.
Attach the pneumatic joint and the XE-axis kit to the X-axis profile using screws.
Mount the synchronous belt, extruder kit, and Z-axis passive block onto the X-axis.
Assemble and install the X-axis tensioner, including the synchronous belt and limit switch.
Mount the Z-axis moving kit and adjust X/Y-axis tensioner tightness for smooth movement.
Attach the gantry profile and connect the display screen kit to the printer.
Mount the material rack, spool holder, and gantry covers onto the printer frame.
Form for registering after-sales service requests, including serial number and fault description.
To Next Page
