1.Touched screen will show the tips after
the printing is finished. Click [OK] and
then open the top cover.
4. After cleaning finished, remove the alcohol in the model by non-dust cloth or air
gun. It is better to solidify the model again by using curing box.
2. Just loose the platform tighten knob
to remove the build plate easily.
3. Remove the printed model by mental scraper knife and put the model into the
cleaning box with anhydrous alcohol to clean excess resin.
Note: Do not damage the FEP film in the resin box or the LCD screen in the
process of removing model.
Postprocessing
Model-01
00h01m 02h57m 899/899
OK
Print completed!
Time: 02h57m
12
To Next Page
Loading...
