www.vtechphones.com
6
Installation
Check for dial tone
After the batteries are charged, pick up the handset and press TALK/FLASH; you should hear a
dial tone. If you do not, refer to the Troubleshooting section in the back of this user’s manual.
Charge the handset battery
The battery may have enough power for short calls. Place the handset in the base, NEEDS
RECHARGING will appear on the handset (if the battery is very low). For best performance, charge
the battery for at least 16 hours before using your telephone.
Language
• Press PROG, then press
or
until LANGUAGE is displayed. Press SELECT.
• The current setting blinks. Press
or
until the screen displays the correct language (English,
Espanol and Francais).
• Press SELECT to save your selection.
Set the dial mode
If you have touch tone service, the phone is ready to use as soon as the battery is charged. If you
have pulse (rotary) service, you’ll need to change the dial mode.
• Press PROG.
• Press
or
until the screen displays DIAL MODE: and the current setting.
• Press SELECT. The current setting blinks.
• Press
or
to select TONE or PULSE.
• Press SELECT to save.
• If the phone will
not be used for a
long period of time,
remove the battery
to prevent battery
damage.
• If you have any
trouble installing
your phone, please
visit our website at
www.vtechphones.
com.
To Next Page
Loading...
Need help?
General
