Getting started
10
Add and register a pendant
When first purchased, charge the pendant in the pendant charger. You
hear three beeps every 10 seconds when the pendant is not registered.
The new pendant should be charged without interruption for at least
30 minutes before registering it to the telephone base.
Make sure the pendant is out of the pendant charger and turned on.
To register a pendant:
Press MENU on the telephone base
when idle.
Scroll to Settings, then press SELECT.
Scroll to Registration, then press SELECT.
The telephone base shows Registering...
Please wait.
Put the pendant in the pendant charger.
The pendant status light flashes red
and green to indicate the registration
is in progress. Then PENDANT
Registered appears on the telephone
base, and both devices beep. The
pendant is now registered with the
telephone base. It takes up to 60
seconds to complete registration.
If you have already set the photo speed
dial keys 1 and 2, the telephone base
displays Copied Photo Speed Dial 1
to Pendant memory 1. Press NEXT,
then the telephone base displays
Copied Photo Speed Dial 2 to
Pendant memory 2. Then press OK.
-OR-
If you have not set the photo speed dial keys 1 and 2, see To set
photo speed dial on page 18 to set them.
If registration fails, the telephone base displays Registration failed.
Start again from Step 1 above.
1.
2.
3.
4.
5.
To Next Page
Loading...
